DUNGS Double Solenoid Valve with Pressure Gauge and Pressure Switch Mounted and Pilot Line Take Off.

1.N-BFN140 Packaged with:

• Flame rod
• Ignition rod
• Burner tube 310S 120 mm
• Air and gas orifices

• Ball Valve
• Gas filter
• Gas flowmeter model QT25-25, G25, min flow 4m3/hr, max flow 40 m3/hr
• Gas stabilizer with filter P1 max 1 bar
• Min and max pressure switch
• Double gas safety solenoids
• Pressure gauge with cock
• Ratio regulator 1:1
• 3. Air pipe with:
• Blower compact 400V
• Min air pressure switch
• Air valve + servomotor 3 points

• Main switch
• Emergency button
• Ermergency light indicator
• Voltage light indicator
• Control unit QBK full B (outside) with status adn error display and reset button (pre-purge programmed)
• Blower protection
• Line protection
• Temperature controller Gefran 1600V modulating (Probe not included)
• Over-temperature device SIL2 (Probe not included)
• Terminals with:

            IN:     -Start contact
                      -Emergency contact
            OUT:  - Burner On feedback
                      - Lockout feedback

The electric actuator belonging to AG8 series is designed to operate gas valves and air dampers in ventilation and air conditioning systems.

Upgrading of existing burner system with New Package Bruciatori Santin MXS-1 Burner, complete with gas train and control panel. 
New burner system designed with EN-746-2 gas train and control system QBK. 

The butterfly valves of the series BFV are DVGW approved to the Norm EN 161 with CE product identification number. They are suitable to be used on residential

Construct and Install Gas distribution header and piping with gas ball valve, gas filter, gas flowmeter, pressure gauge.

CPT quantometers, designed in order to provide a reliable and inexpensive measuring device [non fiscal], with features alike those of fiscal turbine meter, are

Bruciatori Industriali Santin’s MXS series is the world most flexible and reliable industrial burner.

MXS burners provide an extraordinary performance in furnaces, ovens and dryers, paint finishing lines, textile and paper machines, coffee roasters, food ovens incinerators and grain dryers.

Three sizes up to 2,000,000 Kcal/h. This series is available with cast iron or aluminium until 800,000 Kcal/h and stainless steel up to 2,000,000 Kcal/h.
MXS is available in compact mode with blower or in WB version without blower.
 

Some features of MXS Burners:

• Gas Filter with Test Point at Inlet & Outlet
• Imported from Italy
• Registered with Suruhanjaya Tenaga
• Verified by DOSH

New stock of DUNGS gas part arrvied!

• Gas Regulator
• Pressure Swtiches
• Single Solenoid Valves
• Double Solenoid Valves
• Valve Proving System
• Gas Filter
• Pressure Gauge
• Position Siwtch IP54/IP65
• Burner Management System
• Flame Sensor
• Spart Part - Replacement Magnet

GAS BALL VALVE KPC-G - ISO FULL BORE

Materials
1. Body - Ductile Iron – EN-GJS-400-15 (GGG40)
2. Ball - Stainless Steel – X5CrNi18-10 (A304)
3. Stem -  Stainless Steel – X20Cr13 (A420)
4. Seats - PTFE
5. O- Ring - Viton
6. Handle - Carbon steel (Galvanized)

POLIX:

• DVGW certificate 
• ISO 9001-2000
• Conformity assessment with Pressure Equipment Directive 97/23/EC by Module H (full quality assurance)

PRODUCT:
FIRE SAFE AND ANTISTATIC GAS BALL VALVE
GATE VALVE
GLOBE VALVE
BUTTERFLY VALVE
CHECK VALVE
RUBBER FLEXIBLE JOINTS
DIRTY STRAINER FLANGES

Direct acting pressure regulator with adjustable setpoint springs and modular mounted safety shutoff valve (SAV)

In compliance with EN 334 and EN 14382

• Inlet pressures up to 25 bar (2500 kPa)
• High flow rate
• Stable, accurate and sensitive regulation of the outlet pressure • Admission pressure compensation diaphragm for a high regulation accuracy
• External impulse
• Maintenance-friendly